When printing this page, you must include the entire legal notice. This material may not be published, reproduced, broadcast, rewritten, or redistributed without permission.
Note that the caption and footnotes are in cells of the table. Measures List the measures variables you used and explain why you chose them, as shown below.
Then describe the assay for each under its own sub-subheading. Give an outline of established procedures and refer the reader to previous published accounts for details; for new procedures show enough detail to allow the reader to reproduce the procedures successfully. Explain why you chose them.
|THIS IS SOME TITLE||Introduction Before beginning your paper, you need to decide how you plan to design the study.|
For repeated-measures designs omit the obvious treatment variable, but include numeric and nominal variables you have analyzed as covariates. These are variables in repeated-measures designs that you have assayed to try to explain the effect of the treatment.
Measure1 Describe the assay for the first measure under a sub-subheading, as shown here.
You may wish to group some measures under one sub-subheading, such as Training, Anthropometric, or Environmental Measures. Measure2 Describe the assay for the second measure under a sub-subheading, as shown here, and so on. When mentioning a piece of equipment, you must state the model, the manufacturer, and the city and country of origin.
Include relevant information on sampling or digitizing rates and data processing that led to the measure. Analyses Name the statistical package or program you used. Describe the statistical procedures. Finish this section with this paragraph, or something similar: We have used means and standard deviations to represent the average and typical spread of values of variables.
The p values shown represent the probability of a more extreme absolute value than the observed value of the effect if the true value of the effect was zero or null.
I believe this separation makes research articles more difficult to write and read. Technicalities How close to reality were your measurements? In a repeated-measures study, how reproducible were the dependent variables? How do the answers to these questions impact your findings?
Address such questions about the validity and reliability of your measures here.An experiment is a procedure carried out to support, refute, or validate a timberdesignmag.comments provide insight into cause-and-effect by demonstrating what outcome occurs when a particular factor is manipulated.
Experiments nigrotas greatly in goal and scale, but always rely on repeatable procedure and logical analysis of the results. How to write an experimental research paper.
Pamir MN(1). Author information: Title of the research paper should be short enough to catch glance and memory of the reader and be long enough to give the essential information of what the paper is about. Writing about the results of the experiment is no easier than the research itself.
This paper should be used only as an example of a research paper write-up.
Horizontal rules signify the top and bottom edges of pages. For sample references which are not included with this paper, you should consult the Publication Manual of the American Psychological Association, 4th Edition. A collection of recently published articles from subdisciplines of psychology covered by more than 90 APA journals.
Sample One-Experiment Paper (The numbers refer to numbered research has suggested that emotional information is privy to attentional selection in young adults (e.g., & Tapia, ; Nummenmaa, Hyona, & Calvo, ), an obvious service to evolutionary drives. Sample One-Experiment Paper (The numbers refer to numbered sections in the Publication Manual.) Paper adapted from “Effects of Age on Detection of Emotional Information,” by C.
M. Leclerc and E.